Step # 1:
Step # 2:
Step # 3:
Take mobile programmer and download software data before setting room number on the lock.
- Plug programmer into USB port (Note GEN 1: USB-encoder)
- Open software
- Click “download data”
- Wait for confirmation message
Make sure the mobile programmer has the most update to date ‘download data’ in the software. This is the data logic that is transferred between the key cards and software setup and if incorrect, the lock will not function correctly. Any changes to a door in the ‘download data’ in the software will require door re-programming. The software is setup remotely by KAS during client software install.
Step # 4:
Now you can program the locks with the mobile programmer. Take the mobile programmer and do the following:
- Press ‘3’,
- Press ‘Run’,
- Enter ‘Programming Reference Number’
- Press ‘Run’,
- Hold to lock induction area,
- Wait until you see a confirmation message, *Repeat step if this confirmation message is not displayed on the Mobile Programmer. Try holding the Mobile Programmer about 5-10 cm away from lock face and move back and forth to strength the IR signal.
- Rotate privacy snib 90 degrees back and forth to confirm,
- One long beep heard for confirmation,
Programming Reference Number for example: 100317, i.e Building “10”, Floor “03”, Room “17”. This can be found on the ‘Set Room Number’ on the software or on a pre-filled Programming Reference Number Sheet which KAS fills out for every software setup installation after discussing with the clients.
PLEASE NOTE: If you have a GEN1 Mobile programmer, instead of pressing '3' then 'Run'. Press 'Func' 3 times then 'Run'.
Step # 5:
Set the clock; Note: It is possible to do this with the door closed.
- Press ‘1’,
- Press ‘Run’,
- Hold until programmer to lock induction area
- Wait until you see confirmation message, *Repeat step if this confirmation message is not displayed on mobile programmer
- One long beep is heard for confirmation
PLEASE NOTE: If you have a GEN1 Mobile programmer, instead of pressing '1' then 'Run'. Press 'Func' 1 time then 'Run'.
Step # 6:
Finally, present any key card on the lock reader and open the door. This will initialize the lock into an “auto-locking” state and test the RFID reader, electronics and locking function before moving onto the next door.
Things to check;
- 1. Door handles functions correctly (both sides)
- 2. Test with master key card for correct programming
- 3. If the clock is not set, the guest room key cards will not work (as they are limited by time)
Lock programming complete.
If you do not have Access Control Readers installed,
Your system is ready.
Mobile Programmer model differences
- GEN1 Mobile Programmer: Top row of buttons are "RUN" and "FUNC"
- GEN2 Mobile Programmer: Top row of buttons are " RUN" and "CLR"