TOPIC
Browse the latest articles filed under this collection.
These are instructions for a local database, not an SQL-based database. Instructions Close the LMS software. Open any folder and navigate to the top address bar. Type "%localappdata%" in it (see image). Navigate to "Virtual StoreProgram FilesKAS". ...
Premise This guide will talk you through how to connect your Lock-S locks to a gateway and remote control them via the Lock Keeper app. Note: Remote functionality with Lock-S has been deprecated. While this may still work, we cannot guarantee it. ...
Preface This is a full user guide for local management and lock/ACR functionality customization. When using the mobile app or the web interface, please refer to KAS Access or Web Console A PDF copy of this guide is available as an attachment at the ...
(PDA) MANUAL The following pictures are the basic configurations of our handset: Data line------------------------------------------------1 piece Touch pen----------------------------------------------1 piece ...
Replacing the Batteries Batteries are recommended be replaced every 12 months. [Figure 11.3 on User Manual] Replacing batteries will not loose any stored data Remove battery cover by sliding it upward Remove old batteries and replace with new ones ...
Reading the Records from an LMS Lock Take the mobile programmer to the lock you wish to collect the records from 1) Press 2 2) Press RUN 3) Hold to lock induction area, you might have to adjust the position of the ...
1) Upload the data from the PC to the handheld programmer Click Here 2) Proceed to the door lock and Press 1 (Time & Date will display) 3) Press RUN on the programmer 4) Hold the programmer against the lock’s induction area 5) This will beep ...
Step # 1: unscrew all the screws as shown Step # 2: Take the old motor off as shown Step # 3: Plug in the new motor as shown Step # 4: Finally put all the screws back and tighten them.
Programming Guide This article is a compacted user guide. Please see full manual for further instructions and information Notes: To wake the etouch series lock you need to tap (wake up) the LED display with the palm of your hand. *[MANAGEMENT PIN ...
Please see the attachment at the end of this Article
Preface The SAL Platinum electronic lock is a standalone card operated lock. It does not require any software or supporting hardware to operate. OPERATIONS The unlocking modes available; RFID Mifare S50 1K Mechanical Key for emergency access or ...
Please see below for a YouTube video walkthrough on Activating a KAS eTouch Bluetooth Smart Lock Or click the link below to be taken to YouTube https://youtu.be/tME26qs109c
Know your Handle orientation Refer to the picture below and see if you have a left handle lock or a right handle lock LEFT RIGHT Unscrewing unscrew the screws marked on the ...
How to Program master programming code This is the highest authority and has the ability to open the lock and change/remove any other pin code, card, FOB or remote. It can only be altered by completing the following step or completing a FACTORY ...
How to Add a remote controller Tap the keypad and press the following: * 1 2 3 1 2 3 * 6 * a BLUE or GREEN LED emits and now entered into remote controller programming mode. Press the button once on the remote controller to program. You will get a ...